There are a few things to note when using a manipulator
In the use of the manipulator need to pay attention to the following points: in the use of the manipulator, to ensure that the manipulator of the various arm stroke switch good use, fixture size is appropriate, to avoid movement injury. At the same time, the use of suction, quote, clip need to ensure that at least one has a check signal to avoid product extrusion die. When using suction alone, do not short-circuit the suction signal; when using the holding device or clamp alone, the contact limit must be installed to prevent the product from dropping the die. After the manipulator takes out the product, it is necessary to ensure that the shape and appearance of the product will not be destroyed. Die Opening stroke and manipulator movement stroke should be appropriate to avoid because the mold opening distance is too small, mechanical arm fall when the damage fixture. Regular Maintenance manipulator fixture is tight and reliable, whether there is a screw loose. Some of the mold may be fine mouth to big mouth products, so the manipulator can not take the mouth fell under the machine, need to clean up regularly to prevent accumulation of excessive extrusion die.
